C280-6 Generator Set (Medium Speed)

Duty Cycle	Standby, Prime, Continuous
Emissions/Fuel Strategy	IMO - Tier 2
Frequency	60 Hz
Maximum Rating	2000 ekW
Minimum Rating	1650 ekW
Speed	900 rpm

Aspiration	TA
Bore	11in
Compression Ratio	13:01
Displacement	111in³
Engine Model	3606 I-6,4-Stroke Water-Cooled Diesel
Fuel System	Direct unit injection
Governor Type	Generator Set Monitoring System (GMS)
Stroke	11.8in

Dry Weight - Genset (maximum)	74970lb
Height - Maximum	156.6in
Length - Maximum	404in
Width - Maximum	99.62in

Standard Equipment:

Air Inlet System
- Air inlet shutoff
- Aftercooler, fresh water, corrosion resistant coated (air side)
- Turbocharger, watercooled (720 rpm and HFO), engine oil lubricated
- Breather, crankcase, top-mounted
Cooling System
- Water temperature regulator
- Engine coolant water drains
- Jacket water thermostats
Exhaust System
- Includes adapter, Flexible exhaust fitting
- Dry, gas tight, exhaust manifold
- 457 mm (18 in) Cat bolt pattern
Fuel System
- Simplex or Duplex
Generator System
- Custom generator per generator data sheet completed by dealer
Governor System
- UG actuator
Lube System
- Wet oil sump. Includes engine-driven main lubrication & oil pumps, Oil Lines and Oil Pan
- Centrifugal oil filters with single shutoff
- Service side engine mounted on cylinder block inspection covers
- Crankcase explosion relief valves
- Oil filler and dipstick
- Oil pressure regulating valve
Mounting System
- Damper, torsional vibration
- Engine and generator mounting
Starting / Charging System
- Vane type air starter
- Line group for single point custom connection
- Air silencer
- One motor, engine mounted at rear, on left side
General:
- Gear driven pumps: Fuel / Oil / Jacket water / Aftercooler / Oil cooler water
- Paint, Caterpillar yellow

Optional Equipment:

Air Inlet System
- Air inlet adapter
- Soot filter
- Heavy duty air cleaner
- Boost control valve
- Air cleaner louver assembly
- Air cleaner
- Vertical support bracket
Cooling System
- Auxiliary water pump
- Cooling system aids
- Heating aids
- Expansion tank
Exhaust System
- Weld flange and related hardware
- Flexible exhaust fittings
Fuel System
- Fuel system connections
- Fuel priming pump
- Duplex primary fuel strainer
Generator System
- Class F insulation
- 3 Phase, six Leads, WYE
- Busbar connections
- Winding temperature detectors
- Anti-condensation space heaters
Governor System
- 723 Plus
- Digital programmers
- Electronic / actuators
- Battery backup / Power supply
- 2301 A load share
- EGB actuator
Lube System
- Oil pan drain valve
- Lube ANSI adapter (Emergency connection)
Mounting System
- Isolator
- Spring type vibration isolator
- Non-vertically restrained
- Vertically restrained
Starting / Charging System
- Pressure reducing valve
- Compressed air flex hose
General:
- Custom paint colors

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today