C13 Generator Set

Duty Cycle	Standby, Prime
Emissions/Fuel Strategy	Low Fuel, R96/EUIIIa
Frequency	50 Hz
Maximum Rating	450 kVA
Minimum Rating	350 kVA
Speed	1500 rpm
Voltage	380 to 415 Volts

Aspiration	Air to Air Aftercooled
Bore	5.12in
Compression Ratio	16.3:1
Displacement	762.8in³
Engine Model	C13 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Fuel System	MEUI
Governor Type	Adem™A4
Stroke	6.18in

Height - Maximum	84in
Length - Maximum	186.7in
Width - Maximum	79.3in

Standard Equipment:

Turbocharger
Aftercooler core
Air cleaner; light duty with disposable paper filter

EMCP 4.2

Radiator and cooling fan with guard
Caterpillar Extended Life Coolant
Fan drive, battery charging alternator drive
Coolant drain line with valve

Stainless steel exhaust flex, gaskets, raincap & SAE exhaust flange for customer use; shipped loose

Base, formed steel with single wall integral 8-hour fuel tank
Standard open set fuel tank / base supplied

Power center, IP22
Segregated low voltage (AC/DC) wiring panel
Optional LC frame generator - IP23 Protection
Integrated Voltage Regulator
Mandatory Option circuit breaker, IEC, 3 pole, mounted in power centre
A frame generator - IP21 Protection

Coolant drain line with valve
Disposable Air filter
Coolant level sight gauge
Low coolant level sensor
Radiator package mounted
Service indicator

Cat Electronic Governor (ADEM A4)

Oil drain valves
Lubricating oil
Oil Cooler

Captive linear vibration isolators between base and engine-generator
Includes lifting provisions and termination points for coolant and lube oil drain lines

24V battery with rack and cables

Engine and alternator pre-paint, Caterpillar yellow

Optional Equipment:

Global certificate for CIS
EU certificate of conformance

Dual element air cleaner
Single element air cleaner

Power terminal strip
3 Pole (IEC-100% rated) circuit breaker - Motorised
Circuit breaker (IEC) auxiliary contacts
4 Pole (IEC-100% rated) circuit breaker - Motorised
Pad-lockable circuit breaker device
Shunt trip for IEC circuit breaker
3 Pole (IEC-100% rated) circuit breaker
4 Pole (IEC-100% rated) circuit breaker

EMCP 4.3, EMCP 4.4
Volt free contacts
Control panel protective devices: Earth fault relay ; Earth leakage ground fault ; Overload shutdown via breaker ; low fuel level alarm ; Low fuel level shutdown ; High fuel level alarm ; Fuel level sensor
Local alarm modules: Local annunciator
Remote annunciator modules

Stone guards
Radiator duct flange
Low coolant temperature alarm

High ambient sound attenuated enclosures
Sound attenuated enclosures

10, 25 and 35 dBA attenuation
Mufflers - End in / End out
6 and 8 inch flange GP
6 and 8 inch elbow kit
Flexible 8 inch exhaust fittings

Manual fuel transfer pump
Integral dual wall fuel tank base
Fuel transfer system controls

A frame oversize generator
Permanent magnet generator
Ingress protection
A frame CIP generator
LC frame generator
LC CIP generator
Space heaters

Manual sump pump

Narrow skid base

Battery disconnect switch
5 Amp single battery charger
Jacket water heater

What Our Customers Are Saying About Us

Gregory Poole Equipment Company

4.0

Based on 58 reviews

review us on

Tom Corona

1 month ago

Rich Stidd

1 month ago

Carlos Virgilio Sauceda Rivera

3 months ago

John Karpathian

5 months ago

Clean store and great employees

Hunter Flaugher

10 months ago

Hydraulic pump shop is unmatched. I made the mistake of going somewhere else before bringing my pump here. These guys were more than helpful and friendly. Went out of their way to help me find a solution for my problem even when it didn’t benefit them. This is how businesses should be run. I won’t go anywhere else.

Brian Hrudka

1 year ago

Too bad Poole Cat Field Service is better at invoicing than actually getting my machines moving.

A prompt and courteous technician arrived, and correctly diagnosed two problems with my mini Ex. Thank you. I corrected those problems, but machine still did not work.

He diagnosed a fuel problem as a clogged filter, rather than a bad fuel pump which I managed to diagnose. I also figured out, via help on the internet, that the fuel shut-off solenoid was bad.

Machine runs fine now. So my advice is to check the internet, before letting Poole charge you $870 for a two hour field visit. And you can find a perfectly fine aftermarket fuel pump for $20 rather than the $250 that Poole charges... and it arrives faster,

Jacey Price

2 years ago

Need to teach a tech how to drive a service truck. Around 2:48 on highway 40 east, the truck pictured (plate ending in 8236) flew across 3 lanes of traffic to meet the Cleveland rd exit. Almost hit a semi and caused me to swerve with my children in the car. Glad making the exit was more important than children’s lives.