C7.1 ACERT | gregorypoole

Duty Cycle	Standby, Prime
Emissions/Fuel Strategy	Non Regulated, EU Stage IIIA
Frequency	50 Hz
Maximum Rating	220 kVA
Minimum Rating	135 kVA
Speed	1500 rpm
Voltage	110 to 480 Volts

Aspiration	Turbocharged, Air to Air Aftercooled
Bore	4.1in
Compression Ratio	16.0:1, 18.2:1
Displacement	427.8in³
Engine Model	Cat® C7.1
Fuel System	Direct Injection
Governor Type	Mechanical
Stroke	5.3in

Height - Maximum	64in
Length - Maximum	98.4in
Width - Maximum	52in

Standard Equipment:

Air Inlet System
- Air cleaner; light duty with disposable element
Control Panels
- EMCP 4.1
Cooling System
- Radiator and cooling fan with guards
- Fan drive, battery charging alternator drive
- Coolant drain line with valves
- Caterpillar extended life coolant
Fuel System
- Base, formed steel with single wall integral 8-hour fuel tank
- Standard open set fuel tank / base supplied
Exhaust System
- Stub pipe, gaskets, raincap and SAE exhaust flange for customer use; shipped loose
Generator And Generator Attachments
- Segregated low voltage (AC/DC) wiring panel
- Voltage regulator (single phase sensing)
- Tower panel, IP22, bottom cable entry
- 12 Leads
Governing System
- Mechanical and electrical governing system - model dependent
Lube System
- Oil drain line with valve
- Lubricating oil
Generators And Generator Attachments
- IP23 protection
- Circuit breaker, IEC, 3 pole, mounted in tower panel
Mounting System
- Includes lifting provision and drag points
- Captive linear vibration isolators between base and engine-generator
- Captive linear vibration isolators between base and engine-generator
- Termination points for coolant and lube oil drain lines
Starting / Charging System
- 24V battery with rack and cables
General
- Engine and alternator pre-paint, Caterpillar Yellow

Optional Equipment:

Alternator System
- 3 Phase sensing
- Optional LC frame alternators
- Optional LC frame alternator with coastal insulation protection
- R frame auxiliary winding: R2273L4 SE aux alt 07, aux alt 08 and aux alt 10
- Permanent magnet
- Quatrature droop king
- Alternator removal
- Anti-condensation heater
Circuit Breakers
- 4 Pole 250A, 400A and 630 A Circuit Breakers
- Padlockable breaker device
Control System
- 1000001235
- Static battery charger
- Control panel heater
- Volt free contacts for common alarm
- Volt free contacts for generator set running
Control Panel Options
- Overload shutdown via breaker
Cooling System
- Low coolant level shutdown
- Coolant heater
- Low coolant temperature
Enclosures
- Rental options (CAE only) - Single point lift
- Rental options (CAE only) - Rental pack
- Rental options (CAE only) - CEE form sockets for enclosure
- Sound attenuated level 2 enclosure
- Sound attenuated level 1 enclosure
- Rental options (CAE only) - Socket blanking plate
European Certifications
- Upgrade to STD set for CE
Fuel Systems
- Skidbase for CALG enclosure sets
- Open set narrow tankbase
- Low fuel level alarm
- DEFRA bunded fuel tank
- Low fuel level shutdown
- High fuel level alarm
- Compact skidbase for open sets
Global Certifications
- Certification for CIS
Mounting Options
- Electronic governor
- Industrial silencer removal
- Residential silencer
- Battery removal
- Silencer installation kit
Test Reports
- PGS test report @ 1.0 power factor
- PGS test report @ 0.8 power factor
General
- Stone guards / radiator trans flange
Power Termination
- Circuit breaker, IEC, 4 pole
Accessories / Miscellaneous
- Packing case - compact set
- Packing case - canopied set

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

30-220 kVA SA Lvl 1 Enclosure

Contact Us Today