Dipper Payload (Available Dipper Payloads Up To 109 Tonnes [120 tons] When Specified)
Dependent on application and material density
Working Weight - With Dipper and Standard Links
Ballast - Furnished By Customer
These weights will vary slightly depending upon dipper and optional equipment selection
All specifications are based on a 45 m3 (59 yd3) dipper and standard 317.5 cm (125 in) crawlers.
Power Requirements - Voltage
3 phase, 50/60 Hz, 7,200V
Power Requirements - 50 Hz
6,000V, 6,600V, 7,200V, 11,000V
Power Requirements - 60 Hz
Power Requirements - Average Power Demand
Other voltage options available to suit customer requirements
Power Requirements - Peak power
System Voltage - Nominal
50/60 Hz, 7,200V
IGBT Acutrol drive system
One piece, forged, seamless tubular dipper handle and wide-spread boom point sheaves equipped with hoist ropes and dipper padlocks to stabilize dipper handle.
Rope Data - Boom Suspension - Diameter
Rope Data - Boom Suspension - No.
Rope Data - Dipper Trip - Diameter
Rope Data - Dipper Trip - No.
Rope Data - Hoist - Diameter
Rope Data - Hoist - No.
Rope Data - Note
High impact ropes available as an option
HydraCrowd, hydraulic power skid, located at the front center of the revolving frame deck, powers a large hydraulic cylinder to move the dipper handle fore and aft.
(Optional) Rope Crowd, the crowd machinery is located at the front center of the revolving frame, consisting of motor, brake, drum and gearing. Plastic-impregnated crowd and retract ropes are used to move the dipper handle fore and aft.
Automatic, single-line system for open gear lubricant and grease
Six pumps (four for open gear lubricant and two for grease) located in an insulated, heated, double-walled lube room
External fast fill from lower level
Upper Works Overall Width - Including Standard Walkways
Ground Bearing Pressure - Note
Ground bearing pressure is dependent upon many factors
A planetary gearbox with dual-output pinions provides the hoist torque transfer from the electric motor to the hoist drum gear.
Crawler Dimensions - Overall Width 317.5 cm (125 in) Treads
Ground Bearing Pressure - Total Effective Bearing Area (317.5 cm/125 in) Treads
57 m2 (248 kPa); 614 ft2 (36 psi)
Dual-motor independent drive
Two planetary gearboxes, each driven by a vertically mounted motor, are located on either side of the revolving frame. Dual-output pinion shafts from each gearbox engage the swing rack.
Dimensions - Working Ranges
30.6-62.7 m3 (40-82 yd3)
Maximum Dumping Height
Dimensions (Approximate) - Optimal Working Ranges*
Dumping Height - With Clearance to Open Dipper Door
Cutting Height - Maximum
Cutting Radius - Maximum
Radius of Level Floor
Revolving Frame Tail Swing Radius
Optimal working ranges based on loading a Cat 797F truck.
*All specifications are based on a 45 m3 (59 yd3) dipper and standard 317.5 cm (125 in) crawlers.