Marine Power Systems

Cat C32 Auxiliary / Diesel Electric Propulsion Engine (IMO III)

Power Rating

Minimum Rating
1047BHP
Maximum Rating
1332BHP

Engine Specifications

Aspiration
Turbocharged-aftercooled
Emissions
IMO III emissions certified (SCR required)
Bore
5.71in
Configuration
Vee 12, 4-stroke-cycle diesel
Displacement
1959in³
Rotation
Counterclockwise from flywheel end
Stroke
6.38in
Cooling
Heat exchanger or keel cooled
Flywheel Housing
SAE No. 0 with SAE No. 18 flywheel (136 teeth)
Governor
Electronic (A5 ECM)
Oil Change Interval
750 hrs - deep pan
Rated Engine Speed
1500 rpm
Refill Capacity
Lube Oil System w/ oil filter change: 146 L (38.5 gal) - deep pan

Dimensions & Weights

Maximum Engine Dry Weight
7160lb
Maximum Height
63.5in
Maximum Length
89.8in
Maximum Width
57.3in
Minimum Engine Dry Weight
6950lb
Minimum Height
59.3in
Minimum Length
83.9in
Minimum Width
57.1in

Clean Emissions Module (CEM) - Dimensions

6 Brick U-Flow - Height
23.5in
6 Brick U-Flow - Length
85in
6 Brick U-Flow - Weight
1235lb
6 Brick U-Flow - Width
56.9in
6 Brick Z-Flow - Height
23.5in
6 Brick Z-Flow - Length
147.7in
6 Brick Z-Flow - Weight
1246lb
6 Brick Z-Flow - Width
43.5in
Dosing Cabinet - Height
22.8in
Dosing Cabinet - Length
37.4in
Dosing Cabinet - Weight
209lb
Dosing Cabinet - Width
18.8in

Standard Equipment:

  • Air Inlet System
    • Separate circuit aftercooled (SCAC)
    • Closed crankcase fumes disposal
  • Control System
    • 24V control system
  • Cooling System
    • Heat exchanger or Keel Cooling
    • Watercooled exhaust manifold and turbocharger
    • Hard seawater lines – no flexible hoses
    • Flanges for cooling connections, ANSI or DIN
  • Fuel System
    • Duplex fuel filters with hybrid fuel lines
    • Shipped loose primary fuel filter with water separator
    • Fuel transfer and priming pump
  • Lube System
    • Oil fill, simplex filter and dipstick
    • Deep or shallow sump oil pan
  • Mounting System
    • Adjustable front support mounting system
  • General
    • Right or left hand service sides
    • Customer wiring and service tool connector

Optional Equipment:

  • Alarm And Protection
    • MECP I control panel
    • MECP III control panel with Cat® Alarm and Protection System
  • Exhaust System
    • Water-in-fuel and exhaust temperature sensors
    • Muffler
  • Charging System
    • Charging alternator
  • Fuel System
    • Manual or electric fuel priming pump
    • Fuel cooler
  • Lube System
    • Duplex oil filters
  • Power Take-offs
    • Front drives including stub shaft and pump drive
    • Rear SAE A or B pump drives
  • Starting System
    • Starting motors – air, electric or redundant