Industrial

Power Rating

Maximum Power
134HP
Maximum Torque
406lb-ft @ 1500 rpm
Rated Speed
2000-2200 rpm
Minimum Power
94HP

Emission Standards

Emissions
EU Stage V/U.S. EPA Tier 4 Final/ Japan 2014 (Tier 4 Final)

General

Number of Cylinders
4 inline
Cycle
4 stroke
Bore
3.85in
Stroke
4.72in
Displacement
219.7in³
Compression Ratio
17.0:1
Aspiration
Turbocharged aftercooled
Combustion System
Direct injection
Rotation from Flywheel End
Anti-clockwise
Aftertreatment
DOC+DPF+SCR
Cooling System
Liquid

Engine Dimensions*

Length
46.3in
Width
31.8in
Height
40.8in
Dry Weight
1214lb

Disclaimer

Note 1
*Final dimensions dependent on selected options

Standard Equipment:

  • Aftertreatment Equipment
    • Aftertreatment mounted on engine as standard
    • Range of DEF tanks and DEF lines available
  • Air System
    • Standard and heavy duty air cleaners
  • Cooling System
    • 50:50 water glycol mix
    • Detailed guidance on cooling system design and validation available to ensure machine reliability
    • Engine mounted radiator with top tank temperature of 108°C (226°F)
    • Pusher or puller fan options
    • Radiator erosion screen is available
  • Electrical And Electronics
    • 12V and 24V systems
    • Data interface via CANbus J1939
    • Instrument control panel available
    • Full electronic control
    • Glow plugs for best cold starting with minimum battery impact
    • High power alternator and starter motor options
    • Sensors and robust wiring harness included
  • Flywheel And Flywheel Housing
    • SAE3 flywheel housing and flywheel with pilot bore
    • Wide choice of interfaces for common transmissions and hydraulic pumps
  • Fuel System
    • Electronic high pressure common rail
    • Fuel filter - IOPU mounted
    • Standard and heavy duty fuel filtration
    • Water sensor included - early warning for operator
  • General
    • Cold-start capable with standard equipment to -25°C
    • Supplied painted or lacquered
  • Oil System
    • Oil filters - mounting options available on either side of the engine, plus remote
    • Dipsticks - choice of position and length
    • High incline sump. 35° continuous in all directions. Suitable for machines that are used on steep slopes
  • Power Take-off (pto)
    • SAE-A and SAE-B interfaces available

Optional Equipment: