Cat?� C0.7 Diesel Engine

The C0.7 Industrial Diesel Engine is offered in ratings ranging from 12.2-15.3 bkW (16.4-20.5 bhp) @ 2800-3600 rpm. These ratings meet EPA Tier 4 emission standards. They are also available for Europe and, depending on applicable emission standards, may be introduced in other regulated and non-regulated areas. Industries and applications powered by C0.7 engines include: Compactors/Rollers, General Industrial, Mobile Earthmoving Equipment, Mobile Light Towers and Turf and Landscaping.

Pricing: Contact for Pricing

Request a quote

Photos

Pricing: Contact for Pricing

Request a quote

Maximum Power	20.5HP
Maximum Torque	37.1lb-ft @ 2400 rpm
Minimum Power	16.4HP
Rated Speed	2800-3600 rpm

Emissions	U.S. EPA Tier 4 Interim Equivalent

Height	20.8in
Length	18.9in
Weight - Net Dry - Basic Operating Engine Without Optional Attachments	156.5lb
Width	14.6in

Aftertreatment	-
Aspiration	Naturally Aspirated (NA)
Bore	2.6in
Combustion System	Indirect Injection
Compression Ratio	23.5:1
Displacement	46.4in³
Engine Configuration	Inline 3, 4-Stroke-Cycle Diesel
Rotation from Flywheel End	Counterclockwise
Stroke	2.8in

Standard Equipment:

Air Inlet
- Inlet manifold with choice of inlets.
Control System
- Alternator 12 volt 14 amp
- Starter motor 12 volt
- Glow plug starting aid
Cooling System
- Belt-driven coolant pump
- Coolant temperature switch
- Choice of cooling fans
Flywheel And Flywheel Housing
- SAE No. 6 1/2 flywheel
- Choice of SAE No. 5 or standard backplate flywheel housing
Fuel System
- Fuel injection pump
- Spin-on fuel filter
- Electronic Shut-off Solenoid (ESOS)
Lube System
- Closed circuit breather
- Spin-on lube oil filter
- Lube oil pressure switch
- Lube oil sump
General
- Cast iron, engine block
- Cast iron exhaust manifold--side outlet
- Cold start capability to -20° C (-4° F)
- Gradeability 35° continuous
- Paint: Caterpillar yellow, with optional colors available at request

Optional Equipment:

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Contact Us Today

Get In Touch

Call: (800) 451-7278