C13 Generator Set | gregorypoole

Duty Cycle	Standby, Prime
Emissions/Fuel Strategy	Low Fuel Consumption
Frequency	60 Hz
Maximum Rating	400 ekW
Minimum Rating	320 ekW
Speed	1800 rpm
Voltage	380 to 415 Volts

Aspiration	Air to Air Aftercooled
Bore	5.12in
Compression Ratio	16.3:1
Displacement	762.8in³
Engine Model	C13 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Fuel System	MEUI
Governor Type	Adem™A4
Stroke	6.18in

Height - Maximum	84in
Length - Maximum	186.7in
Width - Maximum	79.3in

Standard Equipment:

Air Inlet System
- Aftercooler core
- Air cleaner; light duty with disposable paper filter
- Turbocharger
Control Panel
- GCCP 1.3
Cooling System
- Caterpillar extended life coolant
- Coolant drain line with valve
- Fan drive, battery charging alternator drive
- Radiator and cooling fan with guard
Exhaust System
- Stainless steel exhaust flex, gaskets, raincap & SAE exhaust flange for customer use - shipped loose
Fuel System
- Base, formed steel with single wall integral 8-hour fuel tank
- Standard open set fuel tank/base supplied
Generator And Attachments
- Segregated low voltage (AC/DC) wiring panel
- Power center, IP22
- Integrated voltage regulator (IVR)
- Mandatory option circuit breaker, IEC, 3 pole, mounted in power centre
- A Frame generator - IP21 Protection
- Optional LC Frame generator - IP23 Protection
Governing System
- Cat electronic governor (ADEM A4)
Packaged Generator Set
- Service indicator
- Radiator package mounted
- Low coolant level sensor
- Coolant drain line with valve
- Coolant level sight gauge
- Disposable air filter
Lube System
- Lubricating oil
- Oil drain valves
- Oil cooler
Mounting System
- Captive linear vibration isolators between base and engine-generator
- Includes lifting provisions and termination points for coolant and lube oil drain lines
Starting / Charging System
- 24V battery with rack and cables
General
- Engine and alternator pre-paint, Caterpillar yellow

Optional Equipment:

European Certificates
- EU Certificate of Conformance (CE)
- Global Certification for CIS
Air Inlet System
- Single element air cleaner
- Dual element air cleaner
Circuit Breakers
- 4 Pole (IEC-100% rated) Circuit breaker
- Circuit breaker (IEC) Auxiliary contacts
- 4 Pole (IEC-100% rated) Circuit breaker - Motorised
- Padlockable circuit breaker device
- Power terminal strip
- Shunt trip for IEC circuit breaker
- 3 Pole (IEC-100% rated) Circuit breaker
- 3 Pole (IEC-100% rated) Circuit breakers - Motorised
Control Panels
- GCCP 1.4
- Local alarm modules: Local annunciator
- Volt free contacts
- Control panel protective devices: Earth fault relay ; Earth leakage ground fault ; Overload shutdown via breaker ; Low fuel level alarm ; Low fuel level shutdown ; High fuel level alarm ; Fuel level sensor
- Remote annunciator module
Cooling System
- Stone guards
- Radiator duct flange
- Low coolant temperature alarm
Enclosures
- Sound attenuated enclosures
- High ambient sound attenuated enclosures
Exhaust System
- 6 and 8 inch elbow kit
- Flexible 8 inch exhaust fittings
- 6 and 8 inch flange GP
- Mufflers - End in/end out
- 10, 25 and 35 dBA attenuation
Fuel System
- Manual fuel transfer pump
- Integral dual wall fuel tank base
- Fuel transfer system controls
Generator And Attachments
- Permanent magnet excitation (PMG) generator
- LC frame generator
- LC CIP generator
- A Frame CIP generator
- A Frame oversize generator
- Ingress protection
- Space heaters
Lube System
- Manual sump pump
Mounting System
- Narrow skid base
Starting / Charging System
- 5 Amp single Battery charger
- Jacket water heater
- Battery disconnect switch

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

C13, C15, C18 WP Enclosure. 350-600 kW 60 Hz

C13, C15, C18 SA enclosure. 350-600 kW 60 Hz

C13 Sound Attenuated Enclosure 50 and 60 Hz

Emergency Transfer Load manager

Contact Us Today