306 CR Mini Hydraulic Excavator

Bore	3.4in
Displacement	148in³
Engine Model	Cat C2.4 Turbo
Gross Power - ISO 14396	57.9HP
Net Power	55.9HP
Net Power @ 2,200 rpm - U.S. EPA Tier 4 Final/EU Stage V - ISO 9249/EEC 80/1269	55.9HP
Stroke	4in

Maximum Operating Weight with Cab**	15766lb
Maximum Operating Weight with Canopy**	15633lb
Minimum Operating Weight with Cab*	14266lb
Minimum Operating Weight with Canopy*	14134lb
Note (1)	*Minimum Weight is based on rubber tracks, operator, full fuel tank, standard stick, fixed blade and no bucket.
Note (2)	**Maximum Weight is based on steel tracks with pads, extra counterweight, operator, full fuel tank, long stick, fixed blade and no bucket.
Operating Weight	15766lb

Boom In Reach	117in
Boom Swing - Left	29in
Boom Swing - Right	36in
Cab Height	100in
Dig Depth	162in
Ground Clearance	12in
Maximum Blade Depth	24in
Maximum Blade Height	16in
Maximum Dig Height	241in
Maximum Dump Clearance	182in
Maximum Reach	263in
Maximum Reach - Ground Level	257in
O/A Shipping Length	234in
O/A Track Width	78in
O/A Undercarriage Length	102in
Stick Length	78in
Swing Bearing - Height	27in
Tail Swing with Counterweight	58in
Tail Swing without Counterweight	53in
Track Belt/Shoe Width	16in
Transport Height	95in
Vertical Wall	125in
Width over Upper House	77in

Angle Blade	225lb
Counterweight	551lb
Long Stick	97lb
Steel Tracks with Pads	827lb
XTC Carriage (no tool)	141lb

Gradeability - Maximum	30 degrees
Ground Pressure - Maximum Weight	5.7psi
Ground Pressure - Minimum Weight	5.1psi
Maximum Traction Force - High Speed	6969lbf
Maximum Traction Force - Low Speed	12589lbf
Travel Speed - High	3.1mile/h
Travel Speed - Low	1.7mile/h

Cooling System	2.6gal (US)
Engine Oil	2.1gal (US)
Fuel Tank	34.3gal (US)
Hydraulic System	27.5gal (US)
Hydraulic Tank	14gal (US)

Auxiliary Circuit - Primary - Flow	24gal/min
Auxiliary Circuit - Primary - Pressure	3553psi
Auxiliary Circuit - Secondary - Flow	9gal/min
Auxiliary Circuit - Secondary - Pressure	3553psi
Digging Force - Bucket	11578lbf
Digging Force - Stick - Long	5957lbf
Digging Force - Stick - Standard	6632lbf
Operating Pressure - Equipment	3553psi
Operating Pressure - Swing	3263psi
Operating Pressure - Travel	3553psi
Pump Flow at 2,400 rpm	40gal/min
Type	Load Sensing Hydraulics with Variable Displacement Piston Pump

Boom Swing - Left	60 degrees
Boom Swing - Right	65 degrees
Machine Swing Speed	11r/min

Angle Blade Height	15.7in
Angle Blade Width	78in
Straight Blade Height	15.4in
Straight Blade Width	78in

Roll Over Protective Structure (ROPS)	ISO 12117-2:2008
Tip Over Protective Structure (TOPS)	ISO 12117:1997
Top Guard	ISO 10262:1998 (Level II)

Average Exterior Sound Pressure (ISO 6395:2008)	99dB(A)
Note	European Union Directive “2000/14/EC”
Operator Sound Pressure (ISO 6396:2008)	72dB(A)

Boom In Reach	98in
Boom Swing - Left	29in
Boom Swing - Right	36in
Cab Height	100in
Dig Depth	146in
Ground Clearance	12in
Maximum Blade Depth	24in
Maximum Blade Height	16in
Maximum Dig Height	230in
Maximum Dump Clearance	170in
Maximum Reach	248in
Maximum Reach - Ground Level	241in
O/A Shipping Length	235in
O/A Track Width	78in
O/A Undercarriage Length	102in
Stick Length	62in
Swing Bearing - Height	27in
Tail Swing with Counterweight	58in
Tail Swing without Counterweight	53in
Track Belt/Shoe Width	16in
Transport Height	69in
Vertical Wall	107in
Width over Upper House	77in

Air Conditioning	The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1287). The system contains 0.9 kg of refrigerant which has a CO2 equivalent of 1.287 metric tonnes.

Recyclability	96%

Standard Equipment:

Operator Environment – Cab And Canopy
- Top Guard ISO 10262 1998 Level I
- ROPS ISO 12117-2:2008
- Stick Steer Mode
- Travel Cruise Control
- Control Pattern Changer
- Adjustable Wrist Rests
- Molded Footrests
- Removable, Washable Floor Mat
- Travel Pedals and Hand Levers
- Cat Key with Passcode Option
- Hydraulic Lockout Controls
- High Back, Suspension Seat
- Retractable Seat Belt (75 mm/3 in)
- Coat Hook
- Cup Holder
- Literature Holder
- Mounting Bosses for Top and Front Guards
- Signaling/Warning Horn
- Cab and (left side) Boom Work Lights
- Utility Space for Mobile Phone
- Next Generation Color LCD Monitor (IP66)
  – Fuel Level and Coolant Temperature Gauges
  – Maintenance and Machine Monitoring
  – Performance and Machine Adjustments
  – Numeric Security Code
  – Multiple Languages
  – Camera Ready (IP68 & IP69K)
  – Hour Meter with Wake Up Switch
Operator Environment – Cab Only
- Operator Sound Pressure 72 dB(A) ISO 6396:2008
- HVAC with Automatic Temperature Control
- Integrated Lower Front Window
- Assisted Front Window Overhead Storage
- Rear Window Emergency Exit
- LED Interior Light
- 12V Power Socket
- Radio – Bluetooth^®, Auxiliary, Microphone, USB (charging only)
- Skylight
- Jog dial interface
Undercarriage
- Greased and Lubricated Track
- Hydraulic Track Adjusters
- Tie Down Eyes on Track Frame
- Dozer Straight Blade
- Dozer Float
- Bolt-on, Reversible Wear Edge
- Rubber Tracks
Boom, Stick And Linkages
- One Piece Boom (3055 mm/120.3 in)
- Standard Stick (1580 mm/62.2 in)
- Front Shovel Capable – Pin-on/Manual Coupler/Hydraulic Coupler for Cat Tools
- Thumb Ready
Electrical
- 12 Volt Electrical System
- 90 Ampere Alternator
- 650 CCA Maintenance Free Battery
- Battery Disconnect
- Circuit Breaker
- Ignition Key Stop Switch
- Signaling/Warning Horn
- Product Link^™ Basic (regulations apply)
- Travel Alarm
Other
- Locks on External Enclosure Doors
- Lockable Fuel Cap
- Beacon Socket
- Rear Reflectors

Optional Equipment:

Operator Environment – Cab And Canopy
- Rain Visor
- Next Generation Advanced Monitor (below are all included with Next Generation Advanced Monitor option)
  – Touch Screen
  – Site Reference System
  – High Definition Camera Capable (IP68 & IP69K)
  – Numeric Security Code
Operator Environment – Cab Only
- Cab Heat Only
- Air Suspension Heated Seat
Undercarriage
- Angle Blade
- Extra Tool Carrier (XTC)
- Steel Tracks (450 mm/17.7 in wide)
- Steel Track with Rubber Pads
Boom, Stick And Linkages
- Long Stick (190 mm/78 in)
- Attachments including Buckets, Augers and Hammers
- 2nd Auxiliary Hydraulic Lines
- Boom Lowering Check Valve
- Stick Lowering Check Valve
- Certified Lifting Eye
Electrical
- Product Link Elite (regulations apply)
- Camera
- Rotating Beacon
Guarding
- Heavy Duty Front Guard ISO 10262 1998 Level II
- Mesh Front Guard ISO 10262 1998 Level I
- Overhead Cab Guard ISO 10262 1998 Level II
- Polycarbonate Front Window EN356 P5A (Cab Only)
- Track Guards
Other
- Additional Counterweight
- Water Jacket Heater
- Refueling Pump

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

New 306 CR Mini Hydraulic Excavator in North Carolina

Standard Equipment:

Optional Equipment:

Contact Us Today

Standard Equipment:

Optional Equipment:

S308 Mobile Scrap & Demolition Shear

676 mm (27 in) Ripper

HMF110 Flail Mower

Hydraulic Dual Lock™ Pin Grabber Coupler For 5 Ton Mini Excavators

2036 mm (80 in) Multi-Purpose Bucket With Bolt-On Cutting Edge And Spill Guard

762 mm (30 in) Heavy Duty Capacity Bucket

914 mm (36 in) Heavy Duty Capacity Bucket

619 mm (24 in) Heavy Duty Capacity Bucket

508 mm (20 in) Heavy Duty Capacity Bucket

457 mm (18 in) Heavy Duty Capacity Bucket

406 mm (16 in) Heavy Duty Capacity Bucket

305 mm (12 in) Heavy Duty Capacity Bucket

914 mm (36 in) Heavy Duty Bucket

762 mm (30 in) Heavy Duty Bucket

619 mm (24 in) Heavy Duty Bucket

508 mm (20 in) Heavy Duty Bucket

457 mm (18 in) Heavy Duty Bucket

406 mm (16 in) Heavy Duty Bucket

305 mm (12 in) Heavy Duty Bucket

1500 mm (59 in) Grading Bucket

1200 mm (47 in) Grading Bucket

1600 mm (63 in) Ditch Cleaning Bucket

1300 mm (51 in) Ditch Cleaning Bucket

1000 mm (39 in) Ditch Cleaning Bucket

A68 Auger

A41 Auger

CVP16 Vibratory Plate Compactor

Related Models

301.5 Mini Hydraulic Excavator

307.5 Mini Hydraulic Excavator

326 Hydraulic Excavator

Cat® 336 Hydraulic Excavator

301.7 CR Mini Hydraulic Excavator

308 CR Mini Hydraulic Excavator

330 GC Excavator | 30 Ton Excavator / Digger

301.8 Mini Hydraulic Excavator

308 CR VAB Mini Hydraulic Excavator

330 Excavator | 30 Ton Excavator / Digger

302 CR Mini Hydraulic Excavator

309 CR Mini Hydraulic Excavator

Contact Us Today