Cat® 3512C Industrial Diesel Engine

Maximum Power	1500HP
Maximum Torque	5259lb-ft @ 1500 rpm
Minimum Power	1500HP
Rated Speed	1800 rpm

Emissions	U.S. EPA Tier 2 Equivalent

Height	71.1in
Length	120.8in
Weight - Net Dry - Basic Operating Engine Without Optional Attachments	13400lb
Width	70.3in

Aftertreatment	-
Aspiration	Turbocharged Aftercooled
Bore	6.7in
Displacement	3158in³
Engine Configuration	V-12, 4-Stroke-Cycle Diesel
Rotation from Flywheel End	Counterclockwise
Stroke	7.5in

Standard Equipment:

Air Inlet System
- Air to Air Aftercooled (ATAAC)
- Two turbochargers, rear mounted
Control System
- Electronic Engine Control, RH
Cooling System
- Thermostats and housing
- Gear driven centrifugal jacket water pump
- Connections for radiator cooling
Exhaust System
- Exhaust manifold, dry
- Two turbochargers with watercooled bearings
- Two exhaust outlets, 203 mm (8 in) round flange
Flywheels And Flywheel Housing
- SAE No. 00 flywheel (183 teeth)
- SAE No. 00 flywheel housing
Fuel System
- Fuel filter, LH spin-on type
- Fuel transfer pump
- Electronically controlled unit injectors
Instrumentation
- No standard instrument or gauge panel
Lube System
- Crankcase breather, top mounted
- Oil cooler
- Oil filler and dipstick, LH
- Oil pump
- Oil filter, LH, spin-on type
- Oil pan
Mounting System
- Trunnion front support
Power Take Off
- Front housing, two sided
Protection System
- ECM monitoring system to provide customer programmable engine
- Deration strategies to protect against adverse operating conditions
- Emergency stop logic inputs provided at 40 pin customer interface connection
Starting System
- Dual 24V electric starting motor
General
- Vibration damper
- Lifting eyes
- Paint: Caterpillar yellow

Optional Equipment:

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Cat^® 3512C Industrial Diesel Engine

Standard Equipment:

Optional Equipment:

Contact Us Today