DG300-2 (3 phase) | gregorypoole

Displacement	864.71in³
Emissions/Fuel Strategy	U.S. EPA Certified for Non-Emergency Application
Frequency	60 Hz
Natural Gas Rating	300 eKW
Speed	1800 rpm

Bore	5.31in
Compression Ratio	9.5:1
Engine Model	14.2 L Spark - Ignited
Fuel System	Electronic
Stroke	6.5in

Height	66.1in
Length	136in
Weight	6274lb
Width	57.6in

Standard Equipment:

Cooling
- Closed coolant recovery system
- 50/50 Ethylene glycol antifreeze
- Factory-installed radiator
- Standard ambient temperatures up to 50°C (122°F)
- Radiator and cooling fan complete with protective guards
Air Inlet
- Single element air filter
Fuel
- Low fuel pressure switch
- Primary and secondary fuel shut-off
- Fuel pressure test po
- Dual lock off valves
- Natural Gas or LP Vapor
- NPT connection
Exhaust
- Exhaust outlet with 3” pipe
Generator
- Full load capacity alternator
- Class H insulation material
- Permanent magnet excitation
- Matched to the performance and output characteristics of Cat engines
- Class H insulation material
- Integrated Voltage Regulator
- Permanent magnet excitation
- IP23 Protection
- Full load capacity alternator
Controls
- EMCP 4.2 Series generator set controller
Mounting
- Vibration isolaton (puck type)
- Rubber vibration isolators
Electric Starting And/or Prelube
- Engine electrical system
- Battery cables
- Solenoid activated starter motor
- Solenoid activated starter motor
Electric Power - Package Serial Number Prefix
- Battery charging alternator
Governor
- Electronic governor (non adjustable)
Control Panel
- EMCP 4.2 Series generator set controller
Starting/charging
- Batteries with rack and cables
- 12 volt starting motor

Optional Equipment:

Starting/charging
- Charging alternator
- Battery charger – UL Listed 10 amp
- Jacket water heater
- Battery heater
General
- Suitable for Use as Service Equipment (SUSE)
- UL 2200 package
- Automatic transfer switches (ATS)
- Enclosures: sound attenuated, weather protective
- CSA Certification
Generator
- Anti-condensation heater
- Shunt trip and auxiliary contact breaker
- Thermal magnetic or electronic trip MCCBs
- Oversize and premium generators
- Excitation: [ ] Permanent Magnet Excited (PM)
- Anti-condensation heater

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today