DE165 GC Generator Set (50 Hz)

Duty Cycle	Standby
Emissions/Fuel Strategy	Non Regulated
Frequency	50 Hz
Maximum Rating	163.9 kVA
Minimum Rating	163.9 kVA
Speed	1500 rpm
Voltage	380 to 415 Volts

Aspiration	Turbocharged Air To Air Charge Cooled
Bore	4.1in
Compression Ratio	16.0:1
Displacement	427.8in³
Engine Model	C7.1 I-6, 4-Cycle Diesel
Fuel System	Inline
Governor Type	Mechanical
Stroke	5.3in

Dry Weight - Genset (maximum)	1834lb
Height - Maximum	65.6in
Length - Maximum	130.9in
Width - Maximum	44.6in

Standard Equipment:

Engine
- C7.1, Inline 6 Cylinder, 4 Stroke Diesel
Control Panels
- GCCP 1.1
Alternator
- A Frame Standard Alternator
Fuel Storage
- Single Wall 8 Hour Tank
Governor
- Mechanical Governor
Enclosure
- Cat GC Enclosure
Air, Cooling & Exhaust
- Enclosure Silencer
General
- Engine and alternator pre-paint, Caterpillar Yellow

Optional Equipment:

Auxiliary Supply Voltage
- 120V
Certification
- Certificate of Conformance
- Australia, CIS, Gulf Certification
Fuel Storage
- Dual Wall 8 Hour Tank
- High Fuel Level Alarm
- Single Wall Tank With Containment
- Low Fuel Level Shutdown
- Low Fuel Level Alarm
Alternator Requirements
- Space Heater
Genset Control
- Volt Free Contacts for Common Alarm
- Volt Free Contacts for Genset Running
- Battery Charger
- Panel Mounted Audible Alarm
- Earth Leakage
- USB to RS485 Communications Device
- Earth Fault
- Emergency Stop with Key
- Coolant Heater
- Battery
- Standby Pack (Smart Jacket Water Heater, Battery Charger)
- Low Coolant Level Shutdown
Circuit Breaker
- 4 Pole Circuit Breaker 200A
- 3 Pole Circuit Breaker 630A
- 4 Pole Circuit Breaker 250A
- 3 Pole Circuit Breaker 200A
- 3 Pole Circuit Breaker 250A
- 4 Pole Circuit Breaker 630A
- 4 Pole Circuit Breaker 400A
- Circuit Breaker Padlock
- Neutral Earth Link
- Overload via Alarm Switch on Breaker
- 3 Pole Circuit Breaker 400A
Testing & Packaging
- PGS Test Report @ 1.0PF
- PGS Test Report @ 0.8PF

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today