C18 Generator Set | gregorypoole

Duty Cycle	Standby, Prime
Emissions/Fuel Strategy	U.S. EPA Certified
Frequency	60 Hz
Maximum Rating	750 ekW
Minimum Rating	500 ekW
Speed	1800 rpm
Voltage	208 to 600 Volts

Aspiration	Turbocharged Air to Air Aftercooled
Bore	5.71in
Compression Ratio	14:01
Displacement	1106.3in³
Engine Model	Cat® C18 ATAACTM In-line 6, 4-cycle diesel
Fuel System	Electronic unit injection
Governor Type	Electronic ADEM™ A4
Stroke	7.2in

Height - Maximum	88in
Length - Maximum	138in
Width - Maximum	67in

Standard Equipment:

Air Inlet System
- Aftercooler core
- Turbocharger
Control System
- 3 Pole
- GCCP 1.2
- Right mounted power centre
- Standard breaker
Cooling System
- Jacket water pump, gear driven, centrifugal
- Thermostats and housing
- Coolant level sight gauge
- Coolant level sensor
- Coolant drain valve; terminated on edge of base
- Cooling system filled with Caterpillar extended life coolant
- Radiator and cooling fan with belt guards
Exhaust System
- Exhaust manifold - dry
Fuel System
- Primary fuel filter w/integral water separator and secondary filter
- Flexible fuel lines
- Fuel cooler
- Engine fuel transfer pump
- Fuel priming pump
Generator And Attachments
- Brushless, self-excited 2/3 pitch, random wound
- Insulation Class H and temperature rise
- Power centre, IP22 bottom cable entry
- Segregated low voltage wiring panel
- IP23 Protection
Mounting System
- Anti-vibration mounts (Non-captive)
- Generator mounting and duct pPlate
- Narrow skid base
Protection System
- Overspeed
- Low oil pressure shutdown
- High coolant temperature shutdown
- Low coolant level shutdown
Starting/charging
- 24 Volt electric starting motor

Optional Equipment:

Air Inlet System
- Dual element air cleaner
- Heavy duty canister air filters
Control System
- Annunciators box
- Volt free contact
- Remote E-Stop button
- Discrete I/O module
- Earth (Ground) fault relay
- Local annunciator
- GCCP 1.5
Circuit Breakers
- Auxiliary contacts
- Neutral bar (208V)
- Single LSI motorised circuit breaker
- Single LSI motorised circuit breaker
- External paralleling
Enclosures
- Sound attenuated (SA)
- Weather protective
- Aluminum enclosure
Cooling System
- Stone guards
- Coolant heater
- Jacket water heater with pump
Base / Fuel Tank
- Audio & visual fuel alarm
- Sub Base Dual Wall Fuel Tank: 660, 1000, 1900, 2200 gal
Fuel System
- Sub tank bases: 24 hr & 48 hr
- Integral 8 hour tank base
Generator And Attachments
- LC frame oversize generators
- Space heater control
- PMG, AREP
- Oversize
- Coastal protection (CIP)
Starting And Charging
- Battery disconnect switch
- 5 Amp Battery charger
- Oversize battery set
- Standard battery set
Certifications
- Certification of Compliance � IBC
- CSA 22.2
- Dual IBC & OSHPD
- UL2200 Listed
- Seismic
General
- Tool set
Lube System
- Manual sump pump

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

C13, C15, C18 WP Enclosure. 350-600 kW 60 Hz

C13, C15, C18 SA enclosure. 350-600 kW 60 Hz

C18 Sound Attenuated Enclosure 50 and 60 Hz

Contact Us Today