3516B (50 Hz) Generator Set

Duty Cycle	Standby, Mission Critical, Prime, Continuous
Emissions/Fuel Strategy	Low Fuel, Low Emissions
Frequency	50 Hz
Maximum Rating	2500 kVA
Minimum Rating	2000 kVA
Speed	1500 rpm
Voltage	380 to 11000 Volts

Aspiration	TA
Bore	6.69in
Compression Ratio	15.5:1
Displacement	4764.73in
Engine Model	3516B TA, V-16, 4-Stroke Water-Cooled Diesel
Fuel System	Electronic unit injection
Governor Type	Adem™3
Stroke	8.46in

Dry Weight - Genset (maximum)	40320lb
Dry Weight - Genset (minimum)	31900lb
Height - Maximum	93.2in
Length - Maximum	251.7in
Length - Minimum	233.4in
Width - Maximum	90in

Standard Equipment:

Air Inlet
- Air cleaner
Cooling
- Package mounted radiator
Exhaust
- Exhaust flange outlet
Fuel
- Secondary fuel filter
- Fuel priming pump
- Primary fuel filter with integral water separator
Generator
- Matched to the performance and output characteristics of Cat engines
- IP23 Protection
Power Termination
- Busbar
Control Panel
- EMCP 4.2B
General
- Paint - Caterpillar Yellow except rails and radiators gloss black

Optional Equipment:

Exhaust
- Exhaust mufflers (except Tier 4)
Generator
- Permanent magnet excitation (PMG)
- Internal excitation (IE)
- Anti-condensation heater
- Oversize and premium generators
Power Termination
- Circuit breakers, UL listed
- Circuit breakers, IEC compliant
Control Panels
- Generator temperature monitoring & protection
- Digital I/O module
- Load share module
- EMCP 4.3, EMCP 4.4
- Remote monitoring software
Mounting
- Spring-type vibration isolator
- IBC isolators
- Rubber anti-vibration mounts
Starting/charging
- Oversize batteries
- Charging alternator
- Heavy-duty starting system
- Jacket water heater
- Air starting motor with control and silencer
- Battery chargers
General
- Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
- EU Certificate of Conformance (CE)
- The following options are based on regional and product configuration:
- Enclosures: sound attenuated, weather protective
- Automatic transfer switches (ATS)
- UL 2200 package
- Integral & sub-base UL listed dual wall fuel tanks
- Integral & sub-base fuel tanks
- EEC Declaration of Conformity
- CSA Certification

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Cat Switchgear

Contact Us Today