SG36 Stump Grinder in North Carolina

Back to Home

Cat® Stump Grinders are designed to economically remove stumps in residential, commercial and agricultural settings. They offer increased production over tow-behind grinders in situations where multiple stump removal is required. The right balance of cutting wheel speed and torque makes quick work of most tree varieties.

Pricing: Contact for Pricing

Request a quote
Cutting Depth - Below Ground 20.5in
Cutting Head Extension 11in
Cutting Head Speed at Maximum Flow 1230 rpm
Cutting Head Swing Range 70 degrees
Cutting Height - Above Ground 18.5in
Cutting Wheel Diameter - With Teeth 21.5in
Cutting Wheel Width - With Teeth 3.3in
Cutting Width - Full Swing Range 60in
Drive Method Gerotor Motor- Direct
Drive Shaft Torque at Maximum Pressure 345.9lb/ft
Motor Displacement 6.1in³
Number of Carbide Teeth per Cutting Wheel 32
Optimal Hydraulic Flow 95-125 L/min (25-33 gpm)
Optimal Hydraulic Pressure 207-310 bar (3000-4500 psi)
Overall Height 32in
Overall Length 68.4in
Overall Width 46.3in
Required Hydraulics High Flow XPS
Weight 881.8lb
Renee HerndonRenee Herndon
21:55 29 Feb 24
Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.
Michael BirrenMichael Birren
14:58 24 Feb 24
I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.
David LawrenceDavid Lawrence
13:04 22 Feb 24
Brandon PierceBrandon Pierce
22:00 18 Feb 24
Darin NoeDarin Noe
01:17 16 Feb 24
Jose SotoJose Soto
15:26 23 Sep 23
Hunter ElliottHunter Elliott
16:17 07 Sep 23
Rick Kelly-CrapseRick Kelly-Crapse
21:06 25 Aug 23
They had all my parts for my 3208 Cat.Friendly folks at parts counter.
js_loader