DG125-2 (3 Phase) | gregorypoole

Emissions/Fuel Strategy	U.S. EPA Certified for Stationary Emergency Application
Frequency	60 Hz
Natural Gas Rating	125 ekW
Speed	1800 rpm
Voltage	480 Volts

Aspiration	Turbocharged
Bore	4.35in
Compression Ratio	10.1:1
Displacement	535in
Engine Model	8.8L V8, 4-cycle Gas
Fuel System	Natural Gas
Governor Type	Electronic
Stroke	4.5in

Height	65.2in
Length	119.6in
Weight	3084lb
Width	43.7in

Standard Equipment:

Air Inlet
- Single element air filter
Cooling
- Radiator and cooling fan complete with protective guards
- Standard ambient temperatures up to 50°C (122°F)
Exhaust
- Exhaust outlet with 2.5” pipe
Fuel
- Natural Gas or LP Vapor
- NPT connection
- Dual lock off valves
Generator
- IP23 Protection
- Integrated Voltage Regulator
- Matched to the performance and output characteristics of Cat engines
Governor
- Electronic governor (non adjustable)
Control Panel
- EMCP 4.2 Series generator set controller
Mounting
- Rubber vibration isolators
Starting/charging
- 12 volt starting motor
- Batteries with rack and cables

Optional Equipment:

Generator
- Excitation: [ ] Permanent Magnet Excited (PM)
- Anti-condensation heater
- Oversize and premium generators
Starting/charging
- Battery heater
- Lube oil sump heater
- Jacket water heater
- Battery charger – UL Listed 10 amp
General
- UL 2200 package
- Suitable for Use as Service Equipment (SUSE)
- Automatic transfer switches (ATS)
- Enclosures: sound attenuated, weather protective
- CSA Certification

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today