DG350 (3-Phase) | gregorypoole

Emissions/Fuel Strategy	U.S. EPA Certified for Stationary Emergency Application and Non-Emergency Applications
Frequency	60 Hz
Fuel Type	Natural Gas
Natural Gas Rating	350 ekW
RPM	1800
Voltage	208 - 600 VAC

Aspiration	Turbocharged - Air-to-Air Aftercooled
Bore	5.7in
Compression Ratio	10.5:1
Displacement	1106.3in³
Engine Model	Cat® CG18 In-line 6, 4-cycle Natural Gas
Fuel System	Gas mixer, Venturi
Governor Type	Electronic
Stroke	7.2in

Height	82in
Length	154in
Weight	10721lb
Width	73in

Standard Equipment:

Exhaust
- Dry exhaust manifolds, insulated and shielded
Fuel System
- ECU controlled shutdown solenoid
- Airfuel Ratio Control, Venturi type Air-Gas mixer, throttle controlled valve
Controls
- EMCP 4.2B
- Integrated Voltage Regulator (IVR)
Telematics
- PL444 Product link 4G LTE Telematics
Generator
- Anti-condensation space heater
- SR5
Governing
- Electronic Governing
Starting/charging
- 24V starting motors
General
- Operation and maintenance manuals
- Paint - Caterpillar Yellow except rails are gloss black
- Operation and maintenance manuals
- Parts book

Optional Equipment:

Air Inler
- Air inlet adapters
Cooling
- Inlet/Outlet connections
Exhaust
- Flexible fitting
- Elbow, Flange
- Muffler and spark-arresting muffler with companion flanges
- Exhaust expander
Telematics
- PLG 601 & 641 Product link Telematics
Generator
- Permanent Mangnet Excitation
- Low voltage extension box
- Generator air filter
- European bus bar
- Cable access box
Enclocures
- Sound Attenuated and Weather Protective
Starting/charging
- Jacket water heater
- Space Heaters
- Charging alternator
- Battery with cable and rack (shipped loose)
- Battery charger
- Oversized battery
General
- Engine barring group
- EEC D.O.I and other certifications
- Crankcase explosion relief valve

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today