DE400S GC Generator Set

Duty Cycle	Standby
Emissions/Fuel Strategy	Low Fuel, R96/EUIIIa
Frequency	60 Hz
Maximum Rating	400 ekW
Minimum Rating	400 ekW
Speed	1800 rpm
Voltage	220 to 480 Volts

Aspiration	Air to Air Aftercooled
Bore	4.53in
Compression Ratio	16.5:1
Displacement	567.5in³
Engine Model	C9.3B ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Fuel System	Direct Injection
Governor Type	Adem™A4
Stroke	5.87in

Height - Maximum	84in
Length - Maximum	186.7in
Width - Maximum	79.3in

Standard Equipment:

Engine
- C9.3B, Inline 6 Cylinder, 4 Stroke Diesel
Genset Control
- GCCP 1.1
Governor
- Adem A4
Alternator
- A Frame Standard Alternator
Fuel Storage
- Single Wall 8 Hour Tank
Air, Cooling & Exhaust
- Standard Air Filter
General
- Engine and alternator pre-paint, Caterpillar yellow

Optional Equipment:

European Certificates
- Australia, CIS, Gulf Certification
- EU certificate of conformance
Auxiliary Supply Voltage
- 240V
Alternator Requirements
- Space Heater
- IP Standard @ 21 FUW A-Frame
Fuel Storage
- High Fuel Level Alarm
- Dual Wall 8 Hour Tank
- Single Wall Tank With Containment 01
- Fuel Level Sender
- Low Fuel Level Shutdown
- Low Fuel Level Alarm
Enclosure
- Cat GC Enclosure
Genset Control
- Speed Adjust Potentiometer
- Battery Charger
- Standby Pack (Smart Jacket Water Heater, Battery Charger)
- Voltage Adjust Potentiometer
- PLG Cellular 4G E
- Low Coolant Temperature Alarm
- Battery
- Oil Temperature Display
- PLG Cellular 4G U
- Coolant Heater
- PLG Ethernet
Circuit Breaker
- Overload via Alarm Switch on Breaker
- 3 Pole Circuit Breaker 1250A
- Neutral Earth Link
- 4 Pole Circuit Breaker 630A
- 4 Pole Circuit Breaker 1250A
- 4 Pole Circuit Breaker 800A
- Circuit Breaker Padlock
- Auxiliary Contacts
- 3 Pole Circuit Breaker 800A
- Shunt Trip
- 3 Pole Circuit Breaker 630A
Air, Cooling & Exhaust
- 6" Elbow Kit
- 6" Flange Kit
- 5" Elbow Kit
- 5-6" Exhaust Adapter
- Canopy Silencer
- 6" Muffler - 25 dBA Attenuation
- Dual Element Air Filter
- Single Stage Air Filter
- No Muffler
- 5" Muffler - 10dBA Attenuation

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today