ATC Contactor Based Bypass Isolation Automatic Transfer Switch

Rating Range	100 to 3000A
Switch Type	Contactor Based
Transfer Type	Bypass Isolation

Applicable Testing	CSA C22.2 No. 178 certified IBC 2006, CBC 2007 and OSHPD
Control Power	100-1200A 2-, 3-, 4-pole
System Voltage Application	120 - 600 Vac, 50/60 Hz
Withstand	Up to 65 kAIC withstand

Standard Equipment:

Controls And Wiring
- All controls relays and industrial grade relays are totally encapsulated to minimize exposure to dust and dirt. Lugs are 90º rated and all control wire is #16 AWG, type XLPE with a 125º temperature rating.
Enclosure
- Durable powder-coated steel NEMA 1, 3R or 12 enclosures with three door hinges to ensure proper support of the door and door mounted devices. The hinges have removable hinge pins to facilitate door removal for easy wall mounting or service and are supplied with pad-lockable latches.

Optional Equipment:

Available Options
- Space heaters
- 2- or 4-position test switch
- Multi-meter options available
- Open, closed or delayed transition
- Drawout capabilities on both ATS bypass portions and power switching devices completely interchangeable between ATS and bypass units
- Load sequencing contacts
- Dual drawout type is field configurable for top or bottom conduit entry
- Field selectable, multi ratio, control voltage transformer 50/60 Hz
- Seismic Zone 4 Qualified (BOCA, CBC, IBC, UBC and OSHPD)
- Remote communications
- Surge suppression
- Selectable automatic or non-automatic operation
Optional Delayed Transition Includes:
- Time delay neutral
- Pre-transfer signal with 1 N.O. and 1 N.C. contacts

Gregory Poole Equipment Company

3.9

Based on 46 reviews

review us on

Renee Herndon

21:55 29 Feb 24

Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.

Michael Birren

14:58 24 Feb 24

I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.

13:04 22 Feb 24

22:00 18 Feb 24

01:17 16 Feb 24

15:26 23 Sep 23

OLEKSANDR “Alex” Kovalenko

14:27 18 Sep 23

👍

Hunter Elliott

16:17 07 Sep 23

Rick Kelly-Crapse

21:06 25 Aug 23

They had all my parts for my 3208 Cat.Friendly folks at parts counter.

Standard Equipment:

Optional Equipment:

Contact Us Today