CB1.8 Utility Compactor

Back to Home

The CB1.8 is a 1.8 metric ton utility roller with 1000 mm (39 in) tandem vibratory drums.

Request a quote
Operating Weight 3825lb
Curb Clearance 16in
Ground Clearance 10in
Standard Compaction Width 39in
Static Linear Load 63lb/in
Travel Speed - Maximum 5.3mile/h
Turning Radius - Inside Drum Edge 75in
Engine Model Cat C1.1
Gross Power 24.7HP
Fuel Tank Capacity 7.9gal (US)
Water Spray Tank Capacity 38gal (US)
Centrifugal Force per Drum - Maximum 3057lb
Frequency 3420V/m
Nominal Amplitude - High 0.018in
Drum Diameter 22.5in
Drum Width 39in
Maximum Machine Height 94.5in
Overall Length 80in
Overall Width 44in

Standard Equipment:

  • Operator Environment
    • ROPS Folding
    • Operator Console w/ Emergency Stop, Simple Rocker Switches, and Machine Warning Indicator Lights
    • Dual 12-volt Power Outlet
    • Horn, Backup Alarm
  • Compaction System
    • Folding Scrapers
    • Vibe Selection - Front, Rear, or Both
    • Pressurized, Triple-Filtration Spray System
  • Powertrain
    • Air Cleaner, Dual Element
    • Engine Belt Guard
  • Technology
    • ProductLinkTM
  • Electrical
    • Working Lights
  • Other
    • Vandal Protection - Lockable Hood and Controls Cover
    • Machine Life and Tiedowns

Optional Equipment:

  • Operator Environment
    • Adjustable Suspension Seat w/ Operator Presence Switch
    • ROPS Fixed
  • Electrical
    • Battery Disconnect
    • Roading Lights
    • Rotating Amber Beacon
    • Light Guards
  • Other
    • Single Point Lift

Coming Soon

Renee HerndonRenee Herndon
21:55 29 Feb 24
Dalton was very helpful, The road construction, however, was not! 😂I would rather have to sand paper an alligators @$$ in a phone booth that to get in that mess again.
Michael BirrenMichael Birren
14:58 24 Feb 24
I purchased a used C-15 from a customer of Greg Pool was a running take out. I picked up the engine from the Greg Pool Cat near Nags Head NC. They started they had done all service on this engine stated the hours and all items replaced during the life of engine under their care. I just recently put the engine in my boat after 2 years of building the vessel I find that everything they said about the engine was a LIE!!! Turbo was Bad, After cooler was not updated to the newer version for the C-15 it was missing a terminal Resistor that was clearly stolen off the engine which created a major issue with start up upon installation. Greg Pool Caterpillar stated the hours at 3300 we find out there were 5700 hours. I didn’t do a start up or test run which I regret because i was dealing with a Caterpillar dealer i thought i could trust them. Clearly not Buyers Be Ware if your dealing with Greg Pool Caterpillar in NC. I have 3 of the C-15 engines in my Work boats here in Tampa Fl and my Cat dealership here is Ring power who have done an amazing job to get me going with this Engine. I am very Disappointed in The Caterpillar company for allowing such A dealership to exist.
David LawrenceDavid Lawrence
13:04 22 Feb 24
Brandon PierceBrandon Pierce
22:00 18 Feb 24
Darin NoeDarin Noe
01:17 16 Feb 24
Jose SotoJose Soto
15:26 23 Sep 23
Hunter ElliottHunter Elliott
16:17 07 Sep 23
Rick Kelly-CrapseRick Kelly-Crapse
21:06 25 Aug 23
They had all my parts for my 3208 Cat.Friendly folks at parts counter.
js_loader